Air source heat pumps: Volume & immission guide values
Topics at a glance
The heat generation of a heat pump is based on the compression principle, in which the evaporated refrigerant is compressed and its temperature is raised to the required level. This can produce noises that, above a certain level, may be perceived as annoying by some people.
Technical instructions for protection against noise as a basis for design
With air source heat pumps, there is also active heat recovery through fans, a process which also causes noise. Since the perception of noise is very subjective, it requires a basis for design. This is provided by the technical instructions for protection against noise (TA Lärm), which in turn is regulated as an administrative regulation by the German Immissions Act (BImSchG).
Accordingly, there are several areas in which different levels must be maintained. If a system is used in an industrial area, for example, the noise level can be up to 70 decibels (A). However, if the same system is intended for operation in a hospital or nursing home, then a limit of 45 decibels (A) during the day and 35 decibels (A) at night must not be permanently exceeded.
Immission guide values
The following table shows the guideline values for immission locations outside buildings according to the Technical Instructions on Noise Abatement (TA Lärm).
Individual short-term noise peaks must not exceed the immission guideline values by more than 30 dB(A) during the day and by more than 20 dB(A) during the night.
The immission values for immission location inside buildings or rooms requiring protection as defined by DIN 4109 are considerably lower and are 35 decibels (A) during the day and 25 decibels (A) at night. Rooms requiring protection include:
- Living rooms and bedrooms
- Child's bedroom
- Work rooms/offices
- Teaching rooms/seminar rooms
An eat-in kitchen, which is where the residents live, should also be regarded as a room requiring protection within the sense of No. A.1.3 TA Läärm (in conjunction with DIN 4109, November 1989 edition).
Low-frequency sounds are considered annoying
In addition to compliance with the legally prescribed noise level, the reduction of low-frequency sounds is an important focus. Many people find these annoying, even though the sound level, i.e. the volume, is below the legal limit. Low-frequency sound is the term used to describe the portion of noise that has a frequency of less than 90 Hz. People start to perceive sounds in a range of around 20 Hz.
The reason why low-frequency sounds are nevertheless perceived as irritating is partly because these sounds are only perceptible at higher volumes. In addition, people cannot differentiate sound in this range, which is why low-frequency sounds are commonly referred to as a "hum".
Reducing noise levels through the design of the Viessmann heat pump alone
As sound concerns are becoming increasingly important, Viessmann has, since 2009, introduced numerous design measures to minimise the sound emissions or volume of heat pumps. In the development of our heat pumps, sound specialists and cooling circuit developers work hand in hand to develop highly efficient and quiet heat pumps. In addition to the 3D sound concept, this has also resulted in the AAD system (Advanced Acoustic Design), which probably makes Viessmann heat pumps the quietest heat pumps on the market.
Air source heat pumps from Viessmann are among the quietest appliances on the market
Air source heat pumps from Viessmann are among the quietest appliances on the market. You can find out what else makes them special in the section on benefits of the air source heat pump. How high the noise level of individual heat pump units is depends, among other things, on the coefficient of performance and the distance to adjacent buildings.
