Vitowell easy Deluxe

A power trip at home caused by the turning on of the electric water heater is usually related to electrical wiring/ electrical supply problems that fall under these common causes:

• Wrong wiring connection, or worn/damaged cables that has fused or come into contact with each other, leading to a short circuit
• Failure to wire to a dedicated water heater power point/ front flex outlet. A 3-pin socket outlet should not be used because its power rating is insufficient to support water heater.
• Sharing of the power point/socket with other electrical appliance(s) resulting in electrical overload. The power point for water heater should never be shared.
• Faulty heater switch / power point.

Please consult a Licensed Electrician to check and rectify any electrical problem. If the power trip persists even after an electrical inspection, kindly contact Viessmann Service Support to check and service your water heater unit.

Sometimes, your shower water may not be hot enough due to these reasons:

• Water flow rate is too high:  For instant water heater, the heating element generates heat to the water flowing through it. There is a maximum amount of heat that can be produced when the heater unit reaches its maximum operating power. If the water flow rate is too high, the same amount of heat produced has to be distributed among a larger volume of water flowing through, and so the temperature of the water outflow will be generally lower. In such a situation, turn on the shower tap partially instead, or install a flow restrictor (of around 5-6L/min flow rate ideally) to reduce the water supplying to the water heater.
• Water pressure is too high: When the water is flowing too fast due to high pressure, the fast-flowing water will not be able to heat up efficiently and so the temperature of the water outflow will be lower. Ensure that the water pressure is within the recommended operating range of 0.1 – 6 bar.
• Water supply is too cold: If the temperature of water supply can be significantly lower than usual, even the maximum amount of heat generated may still be insufficient to raise the temperature of the cold water instantly to the desired temperature.

Over time, clogging of sediments at the filters of the stop valve and clogging of showerhead nozzles from the build-up of particulate minerals (e.g. iron, calcium carbonate in household water) can weaken the discharge of water at the shower head. These regular maintenance actions can be taken to maintain the water discharge:

• Remove the filters and flush them with water to remove any trapped sediments
• Remove the showerhead and rinse the deposit away with water